SparkFun Breadboard Power Supply Stick – 5V/3.3V

This is a very simple board that takes a 6-12V input voltage and outputs a selectable 5V or 3.3V regulated voltage. All headers are 0.1″ pitch for simple insertion into a breadboard.
Input power can be supplied to either the DC barrel jack or the two pin header labeled + and -. Output power is supplied to the pins labeled GND and VCC. Board has both an On/Off switch and a voltage select switch (3.3V/5V).
The two sets of four GND and VCC holes are spaced such that when connected to our Basic Breadboard both power busses will be powered.
Note: Headers are not supplied. You will need to supply your own headers to connect this board to a breadboard. Check below for some breakaway header strips.

Read moreFeatures: 6-12V input voltage via barrel jack or 2-pin header 3.3V or 5V regulated output voltage 800mA Operating Current ON/OFF switch Output voltage select switch Power status LED PTC fuse protected power 5.5×2.1mm center positive barrel jack 2.15×0.65″

Questions(FAQs)